1. Welcome to Thailand Vapers, an English language forum for members in Thailand and the rest of Asia to talk about vaping.
    Commonly referred to as e-cigarettes, vaping is really about the use of personal vaporizers (mods) and atomizers (tanks, clearos, RBAs, RDAs, RTAs) filled with e-liquid.
    Are you looking to get started or an old hand at vaping? Everyone is welcome here so sign up today and talk vaping with us!

Coiling School / Tips / Trix

Discussion in 'Rebuildable Atomisers' started by a_spirit, Mar 16, 2016.

  1. Loki
    No Mood

    Loki Trickster. Vaper. Bringer of Ragnarök

    Joined:
    Sep 25, 2015
    Messages:
    258
    Likes Received:
    471
    Location:
    Asgard
    Tips for making a 2 Strand Twisted Build without a drill.

    Before I had a drill I used to..

    Take a strand of 26 or 28 gauge wire about 6 inches (15.24 cm) Fold it in half. Take the end that does not have the fold and twist the ends together to make a place to hold for the pliers.
    The end that has a loop goes around the pen's clip on the cap. (see photo below) Hold the pen with your dominant hand, hold the pliers with your other hand very tight. Spin the pen clockwise, keep spinning until you get the desire effect( I always spin until the loop snaps off the pens cap) You want to hold the pliers and pen far apart and very tight as you twist.


    If your hand gets tired then you can roll it on your pant leg or knee with your hand flat and moving your palm in a forward motion.





    no drill 2 jpg.jpg





    no drill jpg.jpg




    You can do this with 24 gauge.. It is a pain in the ass to do it with out a drill.

    Credit : M.C. Vapes.
     
    a_spirit and Siam Diesel like this.
  2. Longtail1
    Amused

    Longtail1 Vaping Troll

    Joined:
    Sep 2, 2014
    Messages:
    1,621
    Likes Received:
    2,047
    Just read this again and decide to really simplify it.

    To reduce ramp up time reduce the metal mass in the coil by using thinner gauge wire or less wraps of the same wire.

    To reduce overall temperature add mass to the coil to increase the ohms, and the opposite to increase the temperaure over all.

    Clouds high surface/contact area low ohms

    Flavour lower temperature lower airflow high surface area/contact area

    Bit of both somewhere in between the two.

    Should have written this the first time. lmao
     
  3. a_spirit
    Angelic

    a_spirit Thread Starter Swedish n00b

    Joined:
    Oct 18, 2015
    Messages:
    937
    Likes Received:
    1,927
    Location:
    Sweden
    So here is the video that i followed to make my version of micro clapton zipper

    And since i dont have any major problems with doing micro claptons this was an easy to follow build for me..
    If you try it and run into any problems let me know and i´ll try and give you some helpfull tips
     
    Loki and Siam Diesel like this.
  4. JohnKalasin
    No Mood

    JohnKalasin Well-Known Member

    Joined:
    Dec 5, 2015
    Messages:
    299
    Likes Received:
    208
    For compeering Its like rebuilding an original mort in a Volvo 240... I Like Claptons and twisted, But I don't use it as my Kanthal and Nicrome saves me a lot of juice and battery and still delivers a wonderful taste.. Its a work of art this Clapton, twisted, and fused what ever.. After experimenting I found there is no need for this for me.. I get plenty of flavor and vape and I'm sub ohming at a subtank mini or whatever on a single strand of wire.
    This goes for my rta`s with dual coils as well. IMO

    :cheers:
     
    Loki and a_spirit like this.
  5. a_spirit
    Angelic

    a_spirit Thread Starter Swedish n00b

    Joined:
    Oct 18, 2015
    Messages:
    937
    Likes Received:
    1,927
    Location:
    Sweden
    Well we are all same same but diffrent, and thats OK.. But if you like flavor try a Transformer coil, If you dont like to vape arround 100w make the claptons micro and wrap them with flatribbons spaced...
     
  6. JohnKalasin
    No Mood

    JohnKalasin Well-Known Member

    Joined:
    Dec 5, 2015
    Messages:
    299
    Likes Received:
    208


    Sounds confusing and time consuming 55. Getting plenty of flavor with my Billlow v2 nano.. 35-40watts single stand. I have desided to just stick with this for a wile..

    I got 60 cm of usable clapton from 10 meters of wire screwed up big time.. So I'm done with claptons for a wile...

    Thanks I will deffenly get on it again got a Evic 200w now so got plenty of power to play with...

    EDit:
    Got clapton now in my OBS cirus v3, 26/32g nicrome... On the 200w mod reading at .21
    and 78 watts. 19 Amp

    Its to mutch for me.. At 12 mg nic its ok.. With 8-12 hits and I'm good for a hour.
    Clapton coils are so thirsty...
     
    Last edited: Mar 26, 2016
    Loki and a_spirit like this.
  7. a_spirit
    Angelic

    a_spirit Thread Starter Swedish n00b

    Joined:
    Oct 18, 2015
    Messages:
    937
    Likes Received:
    1,927
    Location:
    Sweden
    12mg man your crazy.. Say´s me that makes sick buildes that give me nicokicks from hell on only 6mg :p
    My last build is thirsty and i got a nicokick from hell before i even had vaped in the cotton :D So now im off to the sofa for an hour or so..
     
    Loki likes this.
  8. a_spirit
    Angelic

    a_spirit Thread Starter Swedish n00b

    Joined:
    Oct 18, 2015
    Messages:
    937
    Likes Received:
    1,927
    Location:
    Sweden

    @Darth Vaper Here it is...


    Vaped from my iPhone with adapter to Tapatalk
     
    Siam Diesel likes this.
  9. JohnKalasin
    No Mood

    JohnKalasin Well-Known Member

    Joined:
    Dec 5, 2015
    Messages:
    299
    Likes Received:
    208
    I got a battery drill, where can I buy the stuff that u use in the videoes?
    I tried making clapton with with a pen and my foot. Dident work out well....
    What kind of wire are u using?
     
  10. a_spirit
    Angelic

    a_spirit Thread Starter Swedish n00b

    Joined:
    Oct 18, 2015
    Messages:
    937
    Likes Received:
    1,927
    Location:
    Sweden
    I posted a link to the 3D blueprints of this somewhere arround here, i heard something about 3D printing shops in Thailand.. You should be able to get the blueprint on a USB drive or a link to it and they will print it..
     
  11. a_spirit
    Angelic

    a_spirit Thread Starter Swedish n00b

    Joined:
    Oct 18, 2015
    Messages:
    937
    Likes Received:
    1,927
    Location:
    Sweden
    Sry this is no coil, this is My new way of doing fused claptons, oh micro fused claptons i think it's called.. 2*32g/35g kanthal



    Vaped from my iPhone with adapter to Tapatalk
     
    Siam Diesel likes this.
  12. a_spirit
    Angelic

    a_spirit Thread Starter Swedish n00b

    Joined:
    Oct 18, 2015
    Messages:
    937
    Likes Received:
    1,927
    Location:
    Sweden
    I did it with 2*35/40 also[​IMG][​IMG]
    [​IMG]



    Vaped from my iPhone with adapter to Tapatalk
     
    Siam Diesel and Loki like this.
  13. a_spirit
    Angelic

    a_spirit Thread Starter Swedish n00b

    Joined:
    Oct 18, 2015
    Messages:
    937
    Likes Received:
    1,927
    Location:
    Sweden
    Ok now it's a coil
    Staggered Clapton with a twist..
    Two 24g/32g spaced and 2*35g twisted to wrap em together
    [​IMG][​IMG][​IMG][​IMG]


    Vaped from my iPhone with adapter to Tapatalk
     
    Siam Diesel likes this.
  14. a_spirit
    Angelic

    a_spirit Thread Starter Swedish n00b

    Joined:
    Oct 18, 2015
    Messages:
    937
    Likes Received:
    1,927
    Location:
    Sweden
    Here we go again then..
    Staggered Clapton with micro Clapton..
    Spaced Clapton 24/28
    Micro Clapton 35/40
    [​IMG]


    Vaped from my iPhone with adapter to Tapatalk
     
    Siam Diesel and hotdogs1 like this.
  15. a_spirit
    Angelic

    a_spirit Thread Starter Swedish n00b

    Joined:
    Oct 18, 2015
    Messages:
    937
    Likes Received:
    1,927
    Location:
    Sweden

    Last coil at 65w 0.15ohm


    Vaped from my iPhone with adapter to Tapatalk
     
    Siam Diesel likes this.

Share This Page