Fideling whit DCT pyrex

that is if ur juice is 50/50 its fine.

80vg/20pg or 100%VG you will surely burn the cartos with those tiny holes.

 

But dos small holes make it gurgling. I got hot juice in my mouth on every draw?

 

gurgling means you have flooded the cartomizer.

 

Yes I know, but it dont stop until its only 1/3, left in the thank, if I fill it up again, in a correct way, its start gurgling again.

 

What PV do you use with the tank?

What is the carto resistance?

Gurgling also is cause by not enough of volts/wattage to burn the juice when u make a draw so instead u get gurgling and juice in ur mouth

 

Its a 1,5 ohm and I use 80 Vg 20 PG

 

PV is device not juice.

1.5Ohm u should be using about 3.3-3.6volts on ur device

 

I have tried to fire way over that, started out at 6 watt and all the way up to 9 watt, still gurgling.

 

means you are doing something really wrong.

just watch more videos and play around more and you will get it some day.

and also could just be a bad carto. Get some Boge cartos , they are better than those lousy 1's you have

 

Its bad carto I think, I see the review on it at fasttech, and they change the Carto right away to Boge.

 

when people use cartos , they always use Boge cartos cause its the best carto.

 

I kindly disagree. Ikenvape makes great carto's when you can get them in stock, and I've had some very satisfactory ones from smoketech. However Boge are awesome no doubt.

 

Most of the veteran's in US always recommend Boge.

 

No doubt spacemunk. My only point is that there are some other decent ones out there. I also was hesitant to buy Boge after the Bogegate Scandle Anyway, good to have a friend on here to talk about cartos with