Kayfun Lite Plus and 4 Clones Side by Side

It'll vape great, but I worry about the smallish juice channels with thicker juices. I dremel'd mine out in about 10 seconds.

The Kayfun isn't really a cloud-blower because of the 'limited' airflow, but the vapor is thick and the flavor is clean and intense.

If you use 28AWG or thicker wire, you'll probably never have to change the coil unless you want to. Just pull the cotton and dry burn. If I change flavors, I'll wash the whole thing, blow water through the air hole, scrub the coil a bit with a little brush, dry burn and button it all up.

Very easy to change the cotton. Unscrew everything, pull the old cotton, thread the new cotton, screw on the chimney, snip the cotton, tuck the cotton, put a few drops of juice, tidy up the wick, and close it all up. Takes about 3 minutes, and if you're keeping the same flavor, you only have to do it about once every 15-20 ml.

 

guys .... i really urge you to give the Taifun GT a shot, its massive vapor, massive taste
$19.65 Taifun GT Style Rebuildable Atomizer (5.0mL) at FastTech - Worldwide Free Shipping

Easy to refill,
Builds are good forever
although not that easy to built i did the ESS Style
nice about it that it literally support tons of different builts

 

I don't get it.

Anyway, Kayfun nano kits are finally in stock at FastTech, I'm ordering 2. It's about damn time.

 

i dont get it, whats the nano supposed to be? shorter?? they dont look thin to me

 

Yeah, its shorter. I agree, they don't look that small, but look at the size of the chimney. It looks like it'll take off about 2 cm from the height.

 

$5.19 Kayfun Nano Body Kit at FastTech - Worldwide Free Shipping

 

i really hope they release the 2.1 slim version that would be more helpful

 

I like the idea of the 2.1, but its so damn tall. I guess I would want it if I still used something eGo style or an iTaste VV, but there is no going back for me. 22mm all the way. It might look good on a ProVari, I don't know, I can't stand the tapered top cap.

 

Thed nano kits originally introduced in teh Phillipines, can't remember the link off hand, are meant to take 5mm, I believe, off the top and bottom sections of the tank. I don't know if this is the same as the Fast Tech nano though. Also available are new top caps that do away with the top section of the tank and put it on with the top cap for one piece. Much easier to remove the top, but not good if top filling of course..

 

A little google-fu tells me the original pieces are 14mm each, and FastTech has these at 8mm each, so it looks like a 12mm drop in total. I'm more curious at what the volume of the tank ends up being.

 

agree there is really no point of going back to eGo but for the ePipes the smaller atty look better

 

For size comparison, Atmomixani nemesis with hybrid connector fasttech Kayfun lite with nano kit, versus stealth "vaping pen' versus ego twist with kanger evod tank.