Lemo 2 are they any good?

Any solutions?

 

Happening on one specific mod or all your mods? I haven't had any issues with my subtanks themselves but one or two of my mods with manually-adjustable 510 pins have some flakiness with resistance readings with them or other attys. I have had to adjust the 510 so they make good contact with the atty and then all is well.

 

Just started happening with the Subtank. I am waiting for a spare half hour and am going to thoroughly strip it down.

 

Make sure everything is tight, starting at the deck screws. You could try disassembling the base and reassembling it to make sure everything is tight.

 

That's possibly where the issue lies -I seem to remember loosening the bottom contact and then when I realised I retightened it-it's quite possible somethings not quite right under the base -I am going to pull it apart as soon as I get a minute.

 

Stripped it down, cleaned and rebuilt-got a consistent 0.5 ohms for all of a couple of hours-then it started jumping around again-up to 0.8,0.9,1.0 ohms- so ,it's still not right. Back to the drawing board.

 

Again, curious if it is happening on all your mods or just one in particular. If it's happening on all then the atty is definitely at issue.

 

Seems to only be the Subtank

 

Received today.
Post screws are a huge fail on mine, forced to use the holes same as the Delta II although I did manage to use them with 26ga I'm half expecting the resistance to move before long. I'll see if I can find the replacements for the Lemo Drop. No biggie, just annoying.

Top fill is nice and simple, even though I forgot to close the airflow (remembered whilst filling) it didn't leak.

Drip tip is a bit too wide for my taste but may adjust. Certainly no deal breaker.

Certainly a better vape than the Lemo Drop in Kanthal unless I got lucky first time out and unlucky with the Lemo Drop twenty+ builds later...

 

Any reason why you didn't try the coil and wick supplied with the atty?
I still have it in mine a good week after starting using it every day-getting through at least a tank full per day, as part of my 3 or 4 Mod rotation during the day-my Lemo2 has been a huge success.

 

No reason, I just usually rip them straight out.

 

I find that the production coil usually gives a good vape-it did in this case.

 

Tried lemo2 but very disappointed, couldnt get the flavor
But good vapor which is costed me 4ml/ hour.
I've been trying so many coil
24, 26, 28ga at 0.5-1.2 ohm but .......


Sent from my iPad using Tapatalk

 

Could try wicking differently. That said, this just might not be for you...

 

Yup i think so too, even tried with vertical coil n wicking also same 4ml of liquids/ hour


Sent from my iPad using Tapatalk